Oilcan repair step-by-step?
Hi,I recently picked up an EVO-1 and while it is very clean inside, the belt is missing and the oilcan seems to be dented near the lip of the seal. I'd like to remove the oilcan cover and look inside...
View ArticleRe: Oilcan repair step-by-step?
Pics of my EVO-1 guts:This shows the missing beltThis shows the dent in the oilcan lidThis is the end viewThis shows all of the gunk build-up around the adjustment post
View ArticleRe: Oilcan repair step-by-step?
Here's what I've done so far. I cleaned up the threaded post around the poilcan lid and discovered there was no nut holding it together, only the washer. Then I pried off the lid and found that the...
View ArticleRe: Oilcan repair step-by-step?
With the generous help of Jamie, I was able to remove the oilcan, leaving the screws in the above picture in place. Just pry the lid off of the backside of the oilcan like you do on the front. As it...
View ArticleRe: Oilcan repair step-by-step?
Just wanted to correct, the MCM part appears to be MCM Part #: 42-200 http://www.mcmelectronics.com/product/42-200
View ArticleRe: Oilcan repair step-by-step?
Hey George Jetson, (Loved your show) any further advancements? I have an EVO-1 too, but some things look a bit different in mine. Mine has a small circuit board by the motor and no rubber pulley on...
View Article
